Segway SNARLER ATV 2021 Series - Check Fl Uid Level of Front Brake Oil Cup; Replace Brake Hose

2 - 9
MAINTENANCE
MAINTENANCE
Replace brake hose
◆
Discharge brake fluid from brake hose for
replacement.
◆
Remove oiling bolt of both ends of brake hose and
take out the hose.
◆
Clean overfi lled brake fl uid immediately
!
!
WARNING
WARNING
Brake fluid may quickly destroy painting surface. Any
Brake fluid may quickly destroy painting surface. Any
overfi lled fl uids should be cleaned immediately
overfi lled fl uids should be cleaned immediately
◆
Use new fl at washer on each end of hose connector.
◆
assemble new brake hose in position (refer to
annex) and fasten oiling bolt.
Torque of brake hose oiling bolt
25N·m
25N·m
（
（
2.5kgf·m
2.5kgf·m
，
，
18.4ft·lb
18.4ft·lb
）
）
Check fl uid level of front brake oil cup
Put hand brake main pump accumulator horizontally and
check liquid level in the oil cup.
◆ 【
MAX
】
—highest fl uid level of brake oil cup
◆ 【
MIN
】
—lowest fl uid level of brake oil cup.
If liquid level is lower than
【
MIN
】,
check and refill
brake fl uid.
◆
Procedures to refi ll brake fl uid in the brake hose
◆
Remove front brake oil cup cover and refill same
brake fluid in the brake cup to
【
MAX
】
level and
then fasten its screws.
Torque of oil cap cover screw
1.5N·m
（
（
0.15kgf·m
0.15kgf·m
，
，
13.3in·lb
13.3in·lb
）
）
MAX
MAX
MIN
MIN