ELECTRICAL SYSTEM
14 - 64
Disassembly and assembly of left handlebar
switch
【A】Fixed bolt
◆ Remove the two fi xing bolts with tools;
◆ Remove the switch from the handle;
◆ When installing a new switch, pay attention to snap
the limit of the lower cover into the limit slot of the
handle, and then tighten the two fi xing bolts with a
tool;
【B】Limit point
◆ Rotate the switch around the handle tube after
installation to confi rm whether it is installed in place,
and it should not be able to rotate after installation.
A
A
B
To Next Page
Loading...
