WHEELS AND TIRES
10 - 15
Take the wheels apart
◆ Remove the wheel (see Wheel removal).
◆ Remove cotter pin 【A】
◆
Loosen half shaft nut
【
B
】
◆ Unscrew the mounting bolts, remove the calipers
【
A
】
, and do not let the calipers hang freely.
◆ Remove the axle nut 【B】and then pull down the
hub assembly【C】 and brake disc.
◆
Separate the brake disc from the hub.
Wheel hub assembly
◆ Installing a brake disc (see "Braking" chapter)
Tighten axle nut torque
250 N.m（25 kgf·m，184 ft·lb）
◆ Insert the new cotter 【A】 and bend it to the nut
【B】.
!
◆ When inserting the cotter, if the slotted nut does not
align with the open pin hole in the half shaft, tighten
the nut clockwise until the next hole is aligned.
◆ Loosen once and tighten again as the slot passes
through the nearest hole.
Wheel hub disassembly/assembly
◆ No need to press out hub bolts【A】.
◆ If any hub bolts are damaged, please replace hub
mounting seat 【B】 and bolt 【A】 totally.
A
B
A
B
C
A
B
Wheel hub
To Next Page
Loading...
