2 -
22
MAINTENANCE
make the liquid level reach the bottom of the
fi lling hole thread.
◆
Reinstall the O-ring and fi lling plug
Torque to s
pecifi cation
：
Filling Plug:16~
20N.m
◆
Check for the leak.
!
CAUTION
Dispose of used fl uid properly.
Wheels/Tires
Tire Inspection
【
A
】
Type wear mark
Examine the tire for damage and wear.
If the tire is cut or cracked, replace it.
◆
Observe the tire shoulder to find the tire wear limit
alarm mark "T.W.I", follow the triangle sign to see the
past, found that the tire tread has the corresponding
convex, when the pattern block convex surface wear
to the convex position, you should change the tire,
otherwise due to insufficient strength, the tire will
burst midway
◆
internal damage requiring tire replacement.
◆
Remove any foreign objects from the tread. After
removal,
◆
check for leaks with a soap and water solution.
Standard Tire
Front:
25×8-12/
AT
26×8-12/26×8-14
Rear:
25×10-12/
AT
26×10-12/26×10-14
A
A
CV Axle Joint Boot Inspection
◆
Visually inspect the rear CV Axle shaft joint boot
【
A
】
in accordance with the Periodic Maintenance
Chart or if the shaft is noisy during operation.
◆
If the joint boot is torn, worn, or deteriorated, replace
the joint boot and check the propeller shaft (see
Drive System chapter).
To Next Page
Loading...
