Segway SNARLER ATV 2021 Series - Electric Starter System Procedures

ENGINE-ELECTRICAL SYSTEM
ENGINE-ELECTRICAL SYSTEM
3-3-12
Starter Motor Removal
Starter Motor Removal
◆
Remove
Starter Motor Cable
【
A
】
Starter Motor Mounting Bolts
【
B
】
Starter Motor
【
C
】
Starter Motor Installation
Starter Motor Installation
◆
When installing the starter motor, clean the starter
motor lugs
【
D
】
and crankcase
【
E
】
where the
starter motor is grounded.
★
If the O-ring
【
F
】
shows wear or damage, or if it is
hardened, replace it with a new one.
◆
Apply a small amount of engine oil to the O-ring.
◆
Install
:
Starter Motor
【
C
】
Starter Motor Cable
【
A
】
◆
Tighten:
Torque
StarterMotorMounting Bolts
9.8N•m(1.0 kgf•m, 87 in•lb)
Starter Motor Terminal Nut
4.9 N•m (0.50 kgf•m, 43 in•lb)
CAUTION
CAUTION
Do not tap the end of the starter motor shaft or the
motor may be damaged.
A
A
A
A
D
D
B
B
E
E
C
C
C
C
F
F
Electric Starter System