Segway SNARLER ATV 2021 Series - One-Way Clutch and Starter Gear Procedures

ENGINE-ELECTRICAL SYSTEM
ENGINE-ELECTRICAL SYSTEM
3-3-13
One-Way Clutch Removal
One-Way Clutch Removal
◆
Remove the Alternator Rotor (see Alternator Rotor
Removal).
◆
Hold the rotor with the Flywheel Holder and take out
the One-Way Clutch Bolts [A].
◆
Take out the One-Way Clutch [B].
One-Way Clutch Installation
One-Way Clutch Installation
◆
Install the One-Way Clutch so that the fl ange
【
C
】
fi ts on the recess
【
D
】
of the race.
◆
Apply a non-permanent locking agent:
One-Way Clutch Bolts
【
A
】
◆
Tighten:
Torque
Starter Motor Clutch Bolts
20 N•m (2 kgf•m, 14.5 ft•lb)
One-Way
One-Way
Clutch Inspection
Clutch Inspection
◆
Remove:
Alternator Rotor (see Alternator Rotor Removal)
◆
Fit the Starter One-Way Gear into the One-Way
Clutch.
If the alternator rotor turns counterclockwise
【
A
】
freely
from the Starter One-Way Gear, but not clockwise
【
B
】
,
the clutch is operating correctly.
If the clutch does not operate correctly, or if it makes
noise, disassemble it and examine each part visually.
Replace any worn or damaged parts.
NOTE
NOTE
Examine the Starter One-Way Gear
【
A
】
. Replace it if
it is worn or damaged.
A
A
A
A
A
A
A
A
D
D
B
B
B
B
C
C