FRONT & REAR SUSPENSION
9 - 10
Absorber disassembly
【
A
】
Front absorber
【B】When installing the bolts
support the vehicle with a jack or support frame to make
the wheels do not touch the ground.
◆ Remove the upper and lower mounting bolts and nuts
of the shock absorber with tools【B】
◆
Take out the front shock absorber
【
A
】
Front absorber disassembly
◆ Install the upper end of the front shock absorber into
the frame mounting base, and install the bolts and nuts.
◆ mounting base, and install the bolts and nuts
Install the lower end of the front shock absorber into the
front rocker arm mounting base, and install the bolts and
nuts
◆ arm mounting base, and install the bolts and nuts, Use
tools to fasten the upper and lower mounting bolts and
nuts.
Shock absorber retaining nut torque requirement
45 N·m（4.4kgf·m，32ft·lb）
Rebound damping adjustment
Turn the damping regulator at the bottom with a slotted
screwdriver，Increase the damping in clockwise
direction(H) and decrease it in counter clockwise direction
(S).
There are 14 gears in the compression damping
regulator, which is set to the gear 9 from the factory.
Tool：slotted screwdriver
B
A
To Next Page
Loading...
