VEHICLE BODY AND FRAME
13 - 22
Disassembly
◆ Remove the front lower right arm welding assembly
and the front right upper arm welding assembly;(See
Suspension section for details)
◆ Remove the front left lower arm welding assembly
and the front left upper arm welding assembly;(See
Suspension section for details)
◆ Remove the connection between the front constant
velocity drive shaft and the front Differential
assembly;
◆ Unplug or remove the connectors or cables from
the front Differential assembly, and disconnectThe
connection of the main cable;
◆ Use suitable tools to remove the hoop【A】, and
remove the front Diff erential vent pipe;
◆ Use a suitable tool to remove the 2 bolts 【B】, and
disconnect the front drive shaft Into the connection
with the front Diff erential assembly;
◆ Use a suitable tool to remove the nut piece 3,
remove the bolt piece 2, and pull out the screw Bolt
1, remove the front Differential mounting bracket
assembly;
◆ Remove the bolt 4 with a suitable tool, and remove
the front Diff erential from left to rightFront Diff erential
assembly;
Front drive shaft mounting screw torque
35～45N
·
m（3.5~4.5kgf·m，25.8~33.2ft·lb）
!
Before removing the front Differential assembly, make
sure that the wiring harnesses on the front Diff erential
assembly are completelyThe frame or main cable is
disconnected;
Assembly
When assembling, please reverse the assembly in the
order of disassembly; When assembling, apply proper
amount of thread glue on the mounting screws of the
front drive shaft;
A
B
Front Diff erential repair
To Next Page
Loading...
