EasyManua.ls Logo

Segway SNARLER ATV 2021 Series - Dashboard (Meter)Button Function Introduction; Dashboard (Meter)Disassembly

Segway SNARLER ATV 2021 Series
386 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ELECTRICAL SYSTEM
14 - 54
Dashboard (meter)button function introduction
Short press theAbutton: backlight brightness
adjustment, 5 brightness levels, from dark to bright
Short pressBbutton: switch between metric and
inch
Long press theAbutton: clear the subtotal
mileage
Clock setting: Long press theAandBbutton
to enter at the same time, the hour digit flashes
first, then short press theBbutton to adjust the
flashing digit, short press theAbutton to switch
to the minute digit, after setting the minute digit,
short press theAbutton to save and exit
To reset the total mileage: In the power-off state,
press and hold theAandBbutton at the
same time, then turn on the key to power on, the
interface "CCC--" appears, adjust by pressing the
buttons: short press the left key to shift, short press
the right key to adjust the current position, Put After
adjusting to 378 "CCC--" , perform customer reset.
The condition of customer reset is that the mileage
is within 200KM and the number of customer resets
is less than 5 times.
A
A
A
B
Dashboard (meter)disassembly
!
Before removing the meter, be sure to power off the
vehicle.
First remove the plastic partB
Remove three boltsA
Pull out the connector on the back of the meter,
remove the meter, and replace it with a new one
A
B

Table of Contents

Related product manuals