Segway SNARLER ATV 2021 Series - Assemble; Disassemble; Solenoid Valve Assembly Inspection and Replacement

4 - 28
FRONT AND REAR DIFFERENTIAL
FRONT AND REAR DIFFERENTIAL
Solenoid valve assembly inspection and replacement
If the vehicle is running normally without 4WD, and
the solenoid valve assembly is energized and still not
working, check
【
B
】
and replace it in time.
!
!
WARNING
WARNING
If it is not replaced in time, the 2WD and 4WD will not work
normally
【
A
】
Rear Diff erential end cover
【
B
】
Solenoid valve assembly
Disassemble
◆
Screw out
【
B
】
with a sleeve counterclockwise
T
Tool: Sleeve 29
Assemble
◆
Rotate the new
【
B
】
clockwise into
【
A
】
by the
sleeve, and wipe clean the gear oil spilled around it.
T
Tool: Sleeve 29
Tightening torque of solenoid valve assembly
35N·m
(3.57kgf·m,25.8ft·lb)
(3.57kgf·m,25.8ft·lb)
!
!
CAUTION
CAUTION
After replacement, please make up the gear oil, and check
whether the oil seals and sealing rings are damaged, if any,
please replace them
.
A
A
B
B