Segway SNARLER ATV 2021 Series - Rear Stabilizer Bar Maintenance

FRONT & REAR SUSPENSION
9 - 16
Rear stabilizer bar disassembly
【A】Stabilizer bar buff er sleeve
【B】Rear stabilizer bar
【
C
】
Stabilizer bar mounting
【D】Mounting bracket fi xing bolt
【E】Connecting rod assembly mounting nut
【
F
】
Connecting rod assembly
Rear stabilizer bar maintenance
【A】Straight type oil cup
When the vehicle runs 1000km, it is necessary to
add proper amount of grease into the buffer sleeve of
stabilizer bar by the straight type oil cup【A】.
Special tool：Circlip plier, Bearing drive kit
A
D
A
B
C
E
F
E
Fixing bolt of mounting base torque
requirement
25N·m
（
2.5kgf·m
，
18 ft·lb
）
Connecting rod assembly mounting nut
torque requirement
45 N·m（4.5 kgf·m，33 ft·lb）
Rear stabilizer bar