Segway SNARLER ATV 2021 Series - Disassembly; Front Bumper Repair

VEHICLE BODY AND FRAME
13 - 27
A
Disassembly
◆ Use a suitable tool to remove the mounting bolts
of the front lighting cover to make the front light
disconnected from the welding assembly of the front
bumper;
◆
Use a suitable tool to remove the mounting nuts
for the positive and negative connecting wires of
the winch motor【A】, disconnect the positive
and negative wires of the winch motor from the
connection;
◆
Use a suitable tool to remove the 2 bolts
【
B
】
so
that the guide wheel【C】 is in line with the front
The bumper welding assembly is disconnected;
◆ Use a suitable tool to remove the split pin 【F】,
pull out the pin shaft 【G】, and take out the hook
【
E
】
, take out the cushion
【
H
】
and let the wire
rope 【D】from the guide wheel【C】Go through
the middle, take out the guide wheel 【C】, and
then pass the wire rope
【
D
】
through the middle of
the guide wheel mounting plate of the front bumper
welding assembly to make the wireAble to move
freely;
!
After removing the hook, take out the guide wheel,
please install the hook on the wire rope again So as not
to loose the wire rope on the winch motor and aff ect the
use of the winch;
B
C
F
G
D
E
H
Front Bumper repair