4 -
10
FRONT AND REAR DIFFERENTIAL
FRONT AND REAR DIFFERENTIAL
Bearing and Oil Seal
Ball or Needle Bearing Inspection
Since the bearings are made to extremely close
tolerances,the clearance cannot normally be measured.
Check the ball bearing.
◆
Since the ball bearing is made to extremely close
tolerances, the wear must be judged by feel rather
than measurement.
◆
Spin the bearing by hand to check its condition.
If the bearing is noisy, does not spin smoothly, or
has any rough spots, it must be replaced.
◆
Check the needle bearing
【
A
】
in the front
Diff erential gear- box case.
The rollers in the needle bearing normally wear very little,
and wear is difficult to measure. Instead of measuring,
inspect the bearing for abrasion, color change, or other
damage.
If the bearing is damaged, replace the front Differential
gearbox case.
!
CAUTION
Do not remove bearing
【
C
】【
D
】
for inspection.
Removal may damage it.
B
A
D
C
To Next Page
Loading...
