Segway SNARLER ATV 2021 Series - Page 186

4 - 14
FRONT AND REAR DIFFERENTIAL
FRONT AND REAR DIFFERENTIAL
L
L
H
H
C
C
A
A
B
B
D
D
Bevel Gear Adjustment
◆
The backlash and tooth contact pattern of the bevel
gears must be correct to prevent the gears from
making noise and being damaged.
◆
After replacing any of the backlash-related parts,
be sure to check and adjust the backlash and tooth
contact of the bevel gears. First, adjust backlash,
and then tooth contact by replacing shims
【
A
】
【
C
】
.
【
A
】
Shim(s) 83×71×T, (T=0.1,0.15,0.2,0.5)
【
C
】
Shim(s) 61.5×50×t, (t=0.1,0.15,0.2,0.5)
【
B
】
Diff erential Gear Assy
【
D
】
Drive bevel gear
【
H
】
Assembly end face size of Diff erential Gear
Assy = 96mm
【
L
】
Width of Differential Gear Assy =
【
A
】
+
【
B
】
+
【
C
】
=96mm
◆
The amount of backlash is infl uenced by the driven
bevel gear position more than by the drive bevel
gear position.
◆
Tooth contact locations is influenced by the drive
bevel gear position more than by the driven bevel
gear position.