ENGINE LUBRICATION SYSTEM
ENGINE LUBRICATION SYSTEM
3-1-3
No. Fastener
Torque
Remarks
N·m
kgf·m
ft·lb
1 Oil Pump Drive Gear
2 Flat Key
3 Spacer 10×30×3
4 Bolt M10×1.25×25 80 8 58
5 Oil Pump Idler Gear Shaft
6 Circlip 15
7 Spacer 15×28×1
8 Oil Pump Idler Gear
9 E-Ring 9
10 Spacer12×20×1
11 Oil Pump Driven Gear
12 Oil Pump Shaft
13 Bolt M6×20 10 1 7
14 Oil Pump Cover
15 Outer Gerotor
16 Inner Gerotor
17 Needle Roller 4×15.8
18 Oil Pickup Pipe
19 Strainer Filter
20 Strainer Filter Spring
21 O-Ring 82×3.1
22 Strainer Filter Cover
23 O-Ring 13.8×2.5
24 Bolt M6×25 10 1 7
25 Engine Drain Plug M14 18 1.8 13
26 Oil Filter 18 1.8 13 R
27 Oil Filter Adapter 40 4 28 L
28 Bolt M6×16 10 1 7
29 Oil Cooler
30 O-Ring 19×2.5
31 Oil Pressure Sensor 15 1.5 11 SS
32 Oil Pressure Valve Unit 22 2.2 16 L
33 Oil Pressure Valve Unit Cover
34 Gasket 8
35 Banjo Bolt M8×30 20 2.0 14
G: Apply grease for oil seal and O-ring.
L: Apply a non-permanent locking agent.
O: Apply engine oil.
SS: Apply silicone sealant.
R: Replacement Parts.
To Next Page
Loading...
