Segway SNARLER ATV 2021 Series - Page 54

CRANKSHAFT / TRANSMISSION
CRANKSHAFT / TRANSMISSION
3-2-4
No. Fastener
Torque
Remarks
N·m
kgf·m ft·lb
1 Left Crankcase Assembly SS,O
2 Right Crankcase & Right Cover Combination SS,O
3 Isolator
4 Bolt M6×65 9.8 1.0 87 in•lb S
5 Dowel Pin 6×10
6 Bolt M8×40 26 2.7 20 S
7 Needle Roller Bearing HK121612
8 Bolt M8×70 26 2.7 20 S
9 Flow Orifi ce Φ1 2.5 0.25 21 in•lb L
10 Bearing 6004 O
11 Bearing 6204Z O
12 Bearing 6206 O
13 Piston Injection Hole Plug 4 0.4 35 in•lb L
14 Bearing 6304 O
15 Bearing 6203 O
16 Bearing 6006 O
17 Plate,Bearing Retainer
18 Bolt M6×16 9.8 1.0 87 in•lb L
19 Oil Seal 42×55×8 G
20 Bolt M6×40 9.8 1.0 87 in•lb S
21 Centrifugal Oil-Air Separator
22 Respirator Cover
23 Circlip 20
24 Oil Seal 20×30×7 G
25 Right Crankcase Cover Gasket
26 Oil Seal 35×52×7 G
27 Bolt M6×30 9.8 1.0 87 in•lb S
28 Balance Shaft Assembly
29 Crankshaft Connecting Rod Parts O
G: Apply grease for oil seal and O-ring.
L: Apply a non-permanent locking agent.
O: Apply engine oil.
SS: Apply silicone sealant.
R: Replacement Parts.
S:Follow the specifi c tightening sequence.