1 - 42
8-6 Editing Procedure of Range Designation (Expanded Tape Editing/Option)
Designate a range of program and this “Insertion”, “Deletion” or “Storage” can be done at the
program screen.
• Starting of range editing
Operation...... Press the F3/RANGE EDIT key.
The function changes into that for range editing.
• Designation of range
Operation...... Press the F4/RANGE SET key.
The cursor becomes a frame.
A cursor range increases by moving this. That is a range.
• Release a designation of range
Operation...... Press the F4/RANGE SET key and F3/EXIT key.
It becomes a normal cursor and a range is released.
• Storage of range
Operation...... Press the F5/RANGE STORE key.
A part of range is stored.
If a size of range exceeds 2,048 characters (approx. 5m), “Range exceeds a limit.” is
displayed and not stored.
It can be used by the range insertion at any time, since it is stored until a power turned
off.
• Insertion of range
Operation...... Press the F6/STORE→INSERT key.
Insert a part of storage after the cursor by storage of range.
• Deletion of range
Operation...... Press the F7/RANGE DELETE key.
A part designated by range is deleted.
If the size of range exceeds 2,048 characters (approx. 5m), a message “Range exceeds
limit” is displayed and the storing is ineffective.
While the source power is kept on, the stored data is maintained and the data is
available by F8/DELETE→INSERT whenever desired.
• Inserting deletion
Operation...... Press the F8/DELETE→INSERT key.
The portion stored by range deletion is inserted at the cursor position.
To Next Page
Loading...