1 - 65
(2) Machining time
Accumulate a time during machining. (A time of the start lamp is being on.)
(3) Cutting time
Accumulate a time during cutting feed. (A time during cutting feed by G01, G02 or G03)
(4) Lap time
Measure a lap time between a tool and tool. At the time of tool change set it to zero
automatically. Measurement does not execute while the NC is stand by condition.
13-2 Date and Time
The date and time is displayed by the clock builted in.
The date shows by A.D. and time shows by 24 hours. (1 p.m. is 13 hours.)
Since it is backed up by a battery, it moves even if the power is turned off.
Do not change it unnecessarily, however, if discrepancy of the time has occurred from one cause
or another, it should be set correctly because it uses at the time of periodical check.
To Next Page
Loading...