Seiki VS50 - Automatic Operation; When Machining the First Workpiece, Checking the Newly Created Program; Program Memory Operation

1 - 50
!
WARNING
Caution
10. Automatic Operation
10-1 When Machining the First Workpiece, Checking the Newly Created Program
(1) Go through the steps (1) through (5) mentioned in 4-6-2 “Program Memory Operation”
(2) Turn on the [SINGLE BLOCK] switch. (When this is done, it is recommended to set a
rapid override value to 10% for safety.)
(3)
Press the PROGRAM START button.
(4)
Check one block worth of functioning, press the PROGRAM START button again to
sequentially advance a program.
10-2 Program Memory Operation
Close the front door and the ATC magazine door.
(1) Check that the ALARM lamp on the main operation panel is not lit up.
(2) Check and correct tool length and tool compensation data, if necessary.
(3) Set the mode selector switch to “MEMORY”. For normal operation, at this time, turn
off the DRY RUN, OPTIONAL STOP, MACHINE LOCK, BLOCK SKIP and SINGLE
BLOCK switches, and set the FEEDRATE OVERRIDE, SPINDLE OVERRIDE and
RAPID OVERRIDE switches to 100%.
(4)
Press the RESET button on the setting operation panel.
(5) Call the PROGRAM AUTOMATIC to the display screen by pressing the
F2/PRGRM button to check the initial state.
In order to suspend the machine durintg operation, press STOP button on the
operation panel or turn [ON] SIGNAL BLOCK switch.
In case of emergency, press the EMERGENCY STOP button to immediately stop the
machine on the operation panel.