Seiki VS50 - Page 66

To Next Page

To Previous Page

1 - 61

2) How to display the commanded value screen

Display the general screen → Press the F1/POSITION key → Press the function key

F4/COMMAND VALUE for commanded values → The commanded value screen appears.

Main Page

Default Chapter3
- Table of Contents3
Operation of Machine6
1 Daily Maintenance and Inspection6
2 Outline of Main Operation Panel and NC Operation Panel6
- Operation by Using the Main Operation Panel and Sub-Operation Panel6
- NC Operation Panel20
3 Operational Procedures23
- When Starting the Machine23
- Warming-Up Operation of Spindle24
- Zero Return Procedures25
- When Completing the Daily Operation26
4 Manual Operation27
- Each Axial Feed27
- Rapid Traverse27
- Mounting and Dismounting the Tool28
5 Manual Data Input (MDI) Operation29
- Each Axial Feed29
- Coolant29
- Spindle Speed Change and Spindle Revolution29
- Spindle Positioning30
6 Registration of Program31
- Registration from an External Device31
- Manual Registration by the Address/Numeral Keys32
7 Program No. Search34
- Search by Key in a Program no34
- Search to Utilize the Program List35
8 Edition of Program36
- Preparation in Advance at the Time of the Edition of Program36
- Search of Word37
- Edition of Program38
- Back Ground Editing44
- Copy of Program46
- Editing Procedure of Range Designation (Expanded Tape Editing/Option)47
- Alteration of Word (Expanded Tape Editing)48
- Deletion of Program50
- Arrangement of Program51
- Process after Edition52
9 Output of Program53
10 Automatic Operation55
- When Machining the First Workpiece, Checking the Newly Created Program55
- Program Memory Operation55
- When Inserting Manual Operation in Automatic Operation56
- When Performing MDI Operation in Automatic Operation56
11 Operation of Automatic Tool Changer (ATC)57
- Names of ATC each Section57
- Explanation of Actions58
- Rotation of Tool Storage Magazine (at Single Mode)61
- Attachment and Detachment of Tools62
- Relation between Spindle Nose Key and ATC63
- Attention When Using Oil Hole Tool63
- ATC Program Operation64
- Condition Check During ATC Execution65
12 Setting (Data)67
- Outline67
13 Time Measuring, Data69
- Time Measuring69
- Date and Time70
14 Animated Drawing71
- Outline71
- Drawing Parameter72
15 Parameter Setting75
16 Operations Concerning W-Setter79
- Outline79
- Input Signal and Various Operations79
- Operation for Setting of Work Setter Reference Surface80
- Operation for Setting of Work Setter Reference Hole81
- Operation for Setting of Work Setter Coordinate Modification82
- Manual Overwriting of Work Zero Point Offset Amount83
- Setting Operation of Tool Setter83
- Tool Length Measuring Mode, Tool Diameter Measuring Mode85
- Parameter86
- Others87
17 Safety Guard89
- Safety Guard (Tool Length)89
- Safety Guard (Comparison)93
18 Tool Life Management97
- Spare Tool Management99
- Premachining Tool Check100
- Tool Skip and Tool Reset101
- Tool Life Management Program101
- Tool Life Management Operation105
- Tool Life Screen106
- Spare Tool Screen110
- Tool Status List Screen113
- Tool Life Management Parameters and Their Setting114
- Alarms115
19 Cutting Monitoring Unit116
- Outline116
- Monitoring Method116
- Monitoring Functions117
- Cutting Monitoring Program120
- Data Setting123
- Cutting Monitoring Operation125
- Set Load Screen129
- Load Graph Screen132
- Life Graph Screen133
- Display and Setting of Parameters134
- Alarms138

Seiki VS50 - Page 66

Table of Contents