SENTRON PAC4200 - Page 8

Table of contents
SENTRON PAC4200
8 System Manual, 09/2009, A5E02316180B-02
Table A- 5 Structure - Digital inputs status and digital outputs status for an expansion module
SENTRON PAC 4DI/2DO on slot 2 ..........................................................................................
233
Table A- 6 Modbus Offset 203, Register 2: Limit Violations....................................................................... 234
Table A- 7 Overview of status and diagnostics bytes................................................................................. 234
Table A- 8 Modbus offset 205, tab 2: Structure of PMD diagnostics and status........................................ 235
Table A- 9 Measured variables available with a time stamp ...................................................................... 235
Table A- 10 Meaning of the abbreviations in the "Access" column .............................................................. 237
Table A- 11 Available tariff-specific measured variables.............................................................................. 237
Table A- 12 Meaning of the abbreviations in the "Access" column .............................................................. 238
Table A- 13 Available tariff-specific measured variables.............................................................................. 238
Table A- 14 Meaning of the abbreviations in the "Access" column .............................................................. 238
Table A- 15 Available measured variables: Maximum values with time stamp............................................ 239
Table A- 16 Available measured variables: Minimum values with time stamp............................................. 242
Table A- 17 Harmonics of the voltage .......................................................................................................... 245
Table A- 18 Harmonics of the current........................................................................................................... 247
Table A- 19 Harmonics of the phase-to-phase voltage ................................................................................ 248
Table A- 20 Harmonics of the voltage .......................................................................................................... 249
Table A- 21 Harmonics of the current........................................................................................................... 251
Table A- 22 Configuration settings ............................................................................................................... 254
Table A- 23 Assignment of the values 0 to 241............................................................................................ 260
Table A- 24 Communication settings............................................................................................................ 266
Table A- 25 Settings for the I&M data........................................................................................................... 268
Table A- 26 Commands................................................................................................................................ 269
Table A- 27 MODBUS standard device identification parameters ............................................................... 270
Table A- 28 Errors, comments, and suggestions for improvements ............................................................ 272
Table C- 1 Meaning of abbreviations.......................................................................................................... 275
Figures
Figure 2-1 Safety-related symbols on the device ......................................................................................... 17
Figure 3-1 Sliding window demand .............................................................................................................. 31
Figure 3-2 Maximum sliding window demand of the active power............................................................... 32
Figure 3-3 Load profile, fixed block method ................................................................................................. 34
Figure 3-4 Load profile, rolling block method ............................................................................................... 34
Figure 3-5 Instantaneous and maximum values of the harmonics of the ph-ph voltage referred to the
fundamental ................................................................................................................................
40
Figure 3-6 Graph of the phasor diagram ...................................................................................................... 41