Doc# E166703 8-4
8: Using Ethernet Communication
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Security...........................................none
TX Data rate.....................................54 Mbps auto fallback
Power management.........................Disabled
Soft AP Roaming..............................N/A
Ad-hoc merging................................Enabled
WLAN Max failed packets.................0
7) Security Settings:
SNMP...............................................Enabled
SNMP Community Name..................public
Telnet Setup....................................Enabled
TFTP Download...............................Enabled
Port 77FEh......................................Enabled
Enhanced Password........................Disabled
D)efault settings, S)ave, Q)uit without save
Select Command or parameter set (1..7) to change:
8.3: Configure Network Module
These procedures explain how to set up the MP200 unit on the Network Module.
Only one person at a time can be logged into the network port. This eliminates the
possibility of several people trying to configure the Ethernet interface simultaneously.
8.3.1: Configuration Requirements
• You may want to consult your Network Administrator before performing these
procedures, since some functions may be restricted to the Network Administrator.
• If you have only one Ethernet adapter (network card), the screen displays only that
configuration. You will use this Ethernet adapter to access the MP200 unit's Net-
work Module. You may have to configure the Ethernet adapter in order to use it
To Next Page
Loading...
Need help?
General
