Doc# E166703 8-5
8: Using Ethernet Communication
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
with the MP200 unit's Network Module, using the instructions in 8.3.2: Configuring
the Ethernet Adapter, on page 8-5.
• If you have multiple Ethernet adapters (network cards) installed on your computer,
you must choose, configure and use the correct one to access the Network Module.
• The Ethernet Adapter must be set up for point-to-point connection in order for it to
connect to the MP200 unit's Network module, as follows:
IP Address should be 10.0.0.2
Subnet Mask should be 255.255.255.0
These settings can be made in the Ethernet Adapter. Follow the procedure in the
following section.
8.3.2: Configuring the Ethernet Adapter
1. From the PC’s Start Menu, select Settings>Network Connections or Control
Panel>Network Connections. You will see a screen showing your network con-
nections. An example is shown below. Depending on your Operating system, the
screen you see may look a bit different.
Local Area
Network
Connection
To Next Page
Loading...
