Doc# E166703 10-47
10: Using the Optional Display
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
10.9: Maintenance
Cleaning the Display
CAUTION: EQUIPMENT DAMAGE
• Power off the unit before cleaning it.
• Do not use hard or pointed objects to operate the touch panel, since
it can damage the panel surface.
• Do not use paint thinner, organic solvents, or a strong acid
compound to clean the unit.
Failure to follow these instructions can result in equipment damage.
When the surface or the frame of the display gets dirty, soak a soft cloth in water with
a neutral detergent, wring the cloth tightly and wipe the display.
Periodic Checks
Operation Environment
Refer to the Environmental Specifications in 10.3.1: General Specifications, on
page 10-3.
Electrical Specifications
The input voltage must be within 20.4 to 28.8 VDC.
Related Items
• Are all power cords and cables connected properly? Are there any loose cables?
• Is the display installation nut holding the unit securely?
• Are there scratches or traces of dirt on the installation gasket?
NOTE: A gasket with scratches or dirt may have lost much of its water resistance.
Make sure to change the gasket for one with a water resistance equivalent to IP65f
when scratches or dirt become visible.
To Next Page
Loading...
