Doc# E166703 3-3
3: Mechanical Installation and Maintenance
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
3.3: Cleaning the MP200 Unit
Do NOT clean with power applied. Disconnect power from the
MP200 metering system before following the cleaning procedure.
Ne PAS nettoyer lorsque le compteur est alimenté. Débranchez
l'alimentation du système de mesure MP200 avant d'entreprendre
la procédure de nettoyage.
1. Wipe the MP200 unit with a dry cloth. If stains or other material cannot be removed
with a dry cloth, slightly moisten a cloth with a consumer window cleaner and use
this to remove the stains or other material. Immediately wipe the unit down with a
dry cloth to eliminate remaining moisture. The unit must be completely dry before
being re-energized.
2. Dust may be blown off using room temperature compressed air at a maximum of
20 PSI.
To Next Page
Loading...
Need help?
General
