228-90095F
2
6.3.3 Optical adjustment jigs (targets)
Below is the list of optical adjustment jigs (targets). They are targets with a
reinforcing material (plastic frame). Use these jigs for optical adjustment.
List of Optical Adjustment Jigs
No. Jig P/N Comment
1 Jig for M1 221-94566-91 Delivered product, stocked
2 Jig for fine adjustment of M1 221-94566-92 New product, newly stocked
3 Jig for GR 221-94572-91 Delivered product, stocked
4 Jig for GR (large)* 221-94572-92 New product, newly stocked
5 Dummy cell with target 228-32686-92 Delivered product, custom product
6 Jig for M2 228-34949-91 Delivered product, stocked
7 Jig for M3, SPD-20A 228-46069-91 Delivered product, newly stocked
* Some gratings have a larger width due to a variation during processing (cutting). Use
the jig for gratings with a large width. In most cases, 221-94572-91 for regular size can
be used.
(1) Make a full-size copy of the next page (6.3.3 Optical adjustment jigs
(targets)), cut the targets out with a box cutter, etc., assemble them as
illustrated, and use them as adjustment targets. The M3 target is also
used for the new type M3 mirrors in LC-2010 systems. Also, except for the
M3 target, the other targets can also be used for SPD-10vp series
instruments.
(2) Open the lamp housing and spectroscope room by loosening the screws on
the top covers (4 screws on lamp housing and 5 screws on spectroscope
room).
To Next Page