Shinko FCD-13A - Page 7

7
6.2.5 Program mode ----------------------------------------------------------------------- 36
Fixed value control/Program control switching --------------------------------- 37
Step 1 time ------------------------------------------------------------------------------- 37
Step 2 time ------------------------------------------------------------------------------- 37
Step 3 time ------------------------------------------------------------------------------- 37
Step 4 time ------------------------------------------------------------------------------- 37
Step 5 time ------------------------------------------------------------------------------- 37
Step 6 time ------------------------------------------------------------------------------- 38
Step 7 time ------------------------------------------------------------------------------- 38
6.2.6 Auto/Manual control switching ---------------------------------------------------- 38
6.2.7 Control output OFF function ------------------------------------------------------ 38
6.2.8 MV, Remaining step time indication -------------------------------------------- 38
7. Set value memory function (SM option) ---------------------------------------- 39
8. Operation
8.1 When using the FCD-13A as a Temperature controller ------------------------ 40
8.2 When using the FCD-13A as a Simplified programmable controller ------- 41
9. Action explanations
9.1 OUT1 action ----------------------------------------------------------------------------- 42
9.2 Heater burnout alarm action (option) ---------------------------------------------- 42
9.3 ON/OFF control -------------------------------------------------------------------------- 43
9.4 Pattern end action ---------------------------------------------------------------------- 43
9.5 OUT2 (Heating/Cooling control) action (DR, DS, DA option) --------------- 44
9.5.1 OUT2 (Heating/Cooling control) action ---------------------------------------- 44
9.5.2 When setting Dead band ---------------------------------------------------------- 45
9.5.3 When setting Overlap band with Relay contact output -------------------- 46
9.6 Alarm 1 (A1) to Alarm 4 (A4) action ------------------------------------------------ 47
10. Control actions
10.1 Fuzzy self-tuning ---------------------------------------------------------------------- 49
10.2 PID ---------------------------------------------------------------------------------------- 49
10.3 AT (auto-tuning) of this controller ------------------------------------------------- 50
11. Attached functions ------------------------------------------------------------------- 51
12. Specifications
12.1 Standard specifications -------------------------------------------------------------- 52
12.2 Optional specifications --------------------------------------------------------------- 56
13. Troubleshooting ----------------------------------------------------------------------- 60
14. Character table ------------------------------------------------------------------------- 62