SICK C 4000

Operating Instructions Chapter 13
C 4000 Standard/Advanced
8 009 861/OE59/19-11-04 © SICK AG • Industrial Safety Systems • Germany • All rights reserved
95
Annex
Fig. 23: The correct installation (above) must eliminate the errors (below) standing
behind, reaching below and reaching above ........................................................ 41
Fig. 24: Composition of the swivel mount bracket............................................................. 42
Fig. 25: Mounting sender and receiver using swivel mount brackets .............................. 43
Fig. 26: Composition of the side bracket............................................................................ 44
Fig. 27: Mounting the C 4000 with side bracket................................................................ 45
Fig. 28: Pin assignment system connection M26)×)11 + FE.............................................. 47
Fig. 29: Pin assignment configuration connection M8)×)4................................................. 48
Fig. 30: Pin assignment extension connection M26)×)11 + FE.......................................... 49
Fig. 31: Connecting the contact elements to the EDM...................................................... 50
Fig. 32: Connection of the reset button and the signal lamp “Reset required” to
the extension connection....................................................................................... 51
Fig. 33: Connection of an external teach-in key-operated switch ..................................... 52
Fig. 34: Possible methods of connection of a door switch or )similar to the
emergency stop input............................................................................................. 53
Fig. 35: Connection to the output signal ............................................................................ 54
Fig. 36: Connection of the sender test button ................................................................... 55
Fig. 37: Daily checks of the protective device.................................................................... 58
Fig. 38: Dimensional drawing C 4000 Standard/Advanced without extension
connection, sender................................................................................................. 73
Fig. 39: Dimensional drawing C 4000 Standard, sender with angled system
connection and without extension connection. .................................................... 74
Fig. 40: Dimensional drawing C 4000 Standard/Advanced
with extension connection, sender........................................................................ 75
Fig. 41: Dimensional drawing, swivel mount bracket (mm)............................................... 76
Fig. 42: Dimensional drawing, side bracket (mm).............................................................. 76
Fig. 43: Dimensional drawing deflector mirror PNS 75 (mm)............................................ 77
Fig. 44: Dimensional drawing deflector mirror PNS 125 (mm) ......................................... 78