(2) Following message is displayed in D/L
c: drive reading Error
R)retry A)abort I)ignore
① Replace ‘ KB/KP’ switch to ‘ KB’ . (The switch is in the backside of D/L)
② Insert key board into the key connector for PS2 on the back of D/L.
-à Refer to PAGE 96 ‘ External Input/Output T/B’ article.
④ Enter alphabet ‘ I’ in the key board.
⑤ Move key board again after normal operation of D/L and replace ‘ KB/KP’
switch to ‘ KB’ .
● Above message is displayed when the file is damaged owing to unexpected
failure of power supply. Users should put off D/L power supply according to
normal procedure.
To Next Page
Loading...
