(4) Display is failed in LCD Screen. (D/L is in normal operation)
① Firstly, prepare PC monitor.
② Connect power supply to the monitor. Then connect cable to VGA connector
(for display purpose) in the back of data logger and substitute it as a monitor.
③ Request A/S to the supplier after expedient method.
(5) Key-Pad is not operating.
① Reset D/L. (Power off -> Power on)
② In case Key-pad is still not operated with above measurement, replace
‘ KB/KP’ switch to ‘ KB’ (The switch is in the backside of D/L)
③ Prepare Key-board and connect it to key connector designed for PS2 in the
backside of D/L.
④ Request A/S to the supplier after expedient method.
To Next Page
Loading...
