SICK MAX Series

3 2 1 4
Figure 13: Installation of the position magnet
1
Corrugated spring washer
2
Position magnet
3
Circlip
4
Piston
1. Prepare the piston for installation of the magnet: see "Installation cavity for the
position magnet", page 17.
2. Mount the corrugated spring washer.
3. Mount the position magnet.
4. Mount the retaining ring.
4.3
Installing the encoder
4.3.1 Positioning the O-ring and support ring
1
2
Figure 14: O-ring and support ring
1
Support ring
2
O-ring
The O-ring and support ring are pre-installed as shown in the figure and prevent oil from
penetrating into the connector area.
4 MOUNTING
18
O P E R A T I N G I N S T R U C T I O N S | MAX 8022793/ZXZ4/2018-07-24 | SICK
Subject to change without notice