SICK MAX Series

3 Product description
3.1 Device variants
The device is available in the following variants:
•
M12 male connector (4-pin or 5-pin) or 3-wire PUR cable
Output signals
•
Analog (current, voltage)
•
PWM
•
Digital (CANopen, SAE J1939)
3.2 Product identification
Type code
Table 2: Type code (example)
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
M T X 4 8 N - 1 1 R 1 0 T T
Table 3: Type code Explanation
Position Meaning Description
1 Series M = Mobile
2 Technology A = Magnetostrictive
3 Installation type X = Integrated (hydraulic cylinder)
4 Size 48 = MAX48 diameter
30 = MAX30 diameter
5
6 Version N = Non-Safety
7 Place holder -
8 Diameter
Pressure pipe
1 = 10 mm / 30 mm damping
2 = 10 mm / 36 mm damping
3 = 10 mm / 63 mm damping
7 = 7 mm / 30 mm damping
8 = 7 mm / 36 mm damping
9 = 7 mm / 63 mm damping
9 Voltage supply 1 = 12 VDC
2 = 24 VDC
10 Electrical
Interface
V = Voltage
A = Current
C = Digital CANopen (250 kbit)
J = Digital SAE J1939 (250 kbit)
P = pulse-width modulation, 5 V signal
11 Signal output 10 = current (4 ... 20 mA)
10 = voltage (0.50 ... 4.50 V)
21 = voltage (4.75 ... 0.25 V)
7F = CANopen (node ID 7F Hex)
JD = SAE J1939 (source address JD Hex)
B = pulse width (10 ... 90%)
D = frequency (250 Hz)
12
PRODUCT DESCRIPTION 3
8022793/ZXZ4/2018-07-24 | SICK O P E R A T I N G I N S T R U C T I O N S | MAX
9
Subject to change without notice