14 MCS100FT · Operating Instructions · 8011893 V2-1 · © SICK AG
Product Description
Subject to change without notice
2.3 Interfaces
Standard: Analog and digital interfaces.
Option: RS485/422 (Modbus RTU) SCU Operating Instructions).
2.4 Remote control
2.4.1 Ethernet
Standard: Ethernet (Modbus TCP/IP).
Operation via SOPAS ET (option)
Operator menus and Measuring screens are also available on an external PC via Ethernet
for user comfort (with the engineering tool SOPAS ET “SCU” Operating Instructions).
2.4.2 Modbus
Modbus
®
is a communication standard for digital controls to connect a »Master« device
with several »Slave« devices. The Modbus protocol defines the communication commands
only but not their electronic transfer; therefore it can be used with different digital inter-
faces (for MCS100FT: Ethernet).
2.4.3 OPC (option)
OPC is a standardized software interface that allows to exchange data between the appli-
cations of different manufacturers.
The SICK OPC server is required.
System bus: Ethernet.
2.4.4 QAL3 (option)
Optional QAL3 quality monitoring according to DIN EN 14181 with internal adjustment
standard (filter wheel) or span gas.
Monitoring can be triggered manually or cyclically.
Further information on the Modbus:
● Parameter settings SCU Operating Instructions
● Further information: “SCU Technical Information” manual
Further information on the OPC:
● Parameter settings SCU Operating Instructions
● Further information: “SCU Technical Information” manual
To Next Page
Loading...
