Operation
MCS100FT · Operating Instructions · 8011893 V2-1 · © SICK AG 51
Subject to change without notice
5.7.3 Login (user levels)
Menus: MCS100FT/Login and FID-100FT/Login
● If there is not input in user level 3 for a period of 30 minutes, a dialog window is shown
prompting for confirmation to remain at this user level.
● At user level 1, the menus of user level 3 are not shown or are blocked for inputs. The
blocked fields are then grayed out.
5.7.4 Upload all parameters from device
Menu: MCS100FT
The current parameters are loaded to the operator panel from the analyzer of the
MCS100FT resp. FID-100FT
No further prompts are displayed, the parameters are loaded when the menu item is
touched.
Userlevel Designation Allowed actions Password
12
1
The password cannot be changed.
2
Capital letters
1 None View measured values and parameters No password
3Authorized
Operator
Start actions and change parameters HIDE
The menus of both user levels are described in this Manual.
Menus not allowed for a user level are not displayed.
If it is possible that parameters were changed on the MCS100FT resp. FID-
100FT via the Ethernet (e.g. via SOPAS ET):
Perform “Upload all Parameters from Device” before changing parameters.
Current user level
First enter password for desired
user level ...
Pop-up menu
for desired user level:
Touch desired level
... then login to desired user
level
Return to Measuring mode.
Switches automatically to
user level 1
/System Control Unit/Login
SCU
MCS100FT
Measure
Authorized Operator
Login Back as Operator
****
Current Userlevel: Operator (1)
Userlevel
Password
Exit the Login screen
Current user level retained
To Next Page
Loading...
