SICK MCS100FT - Viewing MCS100 FT Measured Values; MCS100 FT Parameter Settings

52 MCS100FT · Operating Instructions · 8011893 V2-1 · © SICK AG
Operation
Subject to change without notice
5.7.5 Measured values
Menu: MCS100FT/Measured Values
The uncorrected measured values are transferred to the SCU and computed further there
(averaging and conversion to “dry flue gas”).
The calculated values are shown in the System Control Unit/Measuring menu (
 p. 40,
§5.6.6).
● Update interval: Approx. 20 seconds.
5.7.6 Parameters
Menu: MCS100FT/Parameters
This menu shows the uncorrected MCS100FT analyzer measured values (no
moisture correction, no averaging, cross-sensitivities are corrected).
If it is possible that parameters were changed on the MCS100FT via the Ether-
net (e.g. via SOPAS ET):
 Perform “Upload all Parameters from Device” (  p. 51, §5.7.4) before
changing parameters.
/MCS100FT/Measured Values
SCU
MCS100FT
Measure
HCl
mg/m3
0,366
HF
mg/m3
19.565
NH3
mg/m3
2,736
CO
mg/m3
9,976
Device Parameters
Temperature Control
Pressure Control
Logbook
/MCS100FT/Parameters
SCU
MCS100FT
Measure
 p. 53, §5.7.6.1
 p. 54, §5.7.6.2
 p. 54, §5.7.6.3
 p. 54, §5.7.6.4