54 MCS100FT · Operating Instructions · 8011893 V2-1 · © SICK AG
Operation
Subject to change without notice
5.7.6.2 Temperature control
Menu: MCS100FT/Parameters/Temperature Control
This menu shows the temperature setpoints [°C].
5.7.6.3 Pressure control
Menu: MCS100FT/Parameters/Pressure Control
This menu shows the pressure setpoint values [hPa].
5.7.6.4 Logbook
Menu: MCS100FT/Parameters/Logbook
This menu serves to enter the settings for the logbook (
p. 62, §5.7.8.2) of the MCS100FT
analyzer.
(The SCU has an own setting for its own logbook
p. 43, §5.6.7.1)
Designation Remark
Compression Mode: When an error occurs:
- Compressed: - An error counter is incremented.
- Uncompressed: - The error message is saved.
Storage Mode: When the logbook buffer is full:
- Warning :mode - A message is output and no further entries are stored.
- Ring Buffer Mode: - The oldest entries are overwritten with the current entries.
No relevant message is displayed.
Changing the setting deletes the logbook contents.
/MCS100FT/Parameters/Temperature Control
SCU
MCS100FT
Measure
200 deg_C
Measurement Cell Temperature Setpoint (T1)
/MCS100FT/Parameters/Pressure Control
SCU
MCS100FT
Measure
850 hPaMeasurement Cell Pressure Setpoint (P1)
750 hPaEjector Inlet Pressure Setpoint (P2)
/MCS100FT/Parameters/Logbook
SCU
MCS100FT
Measure
Warning: Deletes all logbook entries
Uncompressed
WarningStorage Mode
Ring Buffer Mode
CompressedCompression Mode
To Next Page
Loading...
