8 MCS100FT · Operating Instructions · 8011893 V2-1 · © SICK AG
Important Information
Subject to change without notice
1.1 Main hazards
Overview of important safety information:
1.2 Intended use
1.2.1 Purpose of the device
The MCS100FT is a multicomponent analysis system for continuous flue gas monitoring of
industrial combustion plants (emission measuring system).
The sample gas is extracted at the sampling point and fed through the analysis system
(extractive measurement).
1.3 Responsibility of user
Designated users
The MCS100FT may be operated by competent persons only who, based on their device-
specific training and knowledge of the device as well as knowledge of the relevant regula-
tions, can assess the tasks given and recognize the dangers involved.
Correct use
Only use the device as described in these Operating Instructions.
The manufacturer bears no responsibility for any other use.
Perform the prescribed maintenance.
No components may be removed, added or changed on the device unless described
and specified in the official manufacturer information. Otherwise:
– The device could become dangerous.
– Any warranty by the manufacturer becomes void.
Special local conditions
In addition to these Operating Instructions, follow all local laws, technical rules and
company-internal operating directives applicable at the respective installation location
of the device.
Retention of documents
These Operating Instructions and the System Documentation:
Must be available for reference.
Must be passed on to new owners.
Moist instrument air damages the interferometer.
Always follow the instrument air specification (
p. 101).
WARNING: Risk of explosions on MCS100FT with FID-100FT
The FID-100FT is supplied with hydrogen. Risk of explosions due to leaky lines.
Do not plug or block exhaust air openings (
p. 20, §3.2).
Do not operate the MCS100FT with FID-100FT in closed rooms
OR
install a hydrogen sensor (H
2
sensor) (< 25% LEL)
To Next Page
Loading...
