40 MCS100FT · Operating Instructions · 8011893 V2-1 · © SICK AG
Operation
Subject to change without notice
5.6.5 Start screen
Menu: System Control Unit/Start screen
The Start screen is automatically displayed after the start of the SCU or after touching the
“Measure” field.
You can select the desired Start screen from the displayed list of Measuring screens
(
§5.6.6).
5.6.6 Measuring screen
Menu: System Control Unit/Measuring
Select the desired parametrized Measuring screen from the list shown.
● Measuring screens comprise:
– Measured value box (
p. 41, §5.6.6.1)
–Bargraph (
p. 42, §5.6.6.2)
– LineWriter (
p. 42, §5.6.6.3)
● Setting Measuring Screen parameters ( “SCU Technical Information“ manual)
Refresh interval for display: Approx. 1 second
Pop-up menu
for selection of the desired Start screen
(Measuring screen).
/System Control Unit/Start screen
SCU
MCS100FT
Measuring
Select the Startup screen here
/System Control Unit/Measuring/Measuring Screen 1
/System Control Unit/Measuring/Measuring Screen 2
/System Control Unit/Measuring/Measuring Screen 3
/System Control Unit/Measuring/Measuring Screen 4
/System Control Unit/Measuring/Measuring Screen 5
/System Control Unit/Measuring/Measuring Screen 6
/System Control Unit/Measuring/Measuring Screen 1
/System Control Unit/Measuring/Measuring Screen 1
Measuring Screen 1
Measuring Screen 2
/System Control Unit/Measuring/
SCU
Measuring
Touch desired display.
To Next Page
Loading...
