SICK MCS100FT - SCU Parameter Setting Options; Testing SCU Interfaces (Digital;Analog)

Operation
MCS100FT · Operating Instructions · 8011893 V2-1 · © SICK AG 45
Subject to change without notice
5.6.8 Parameter setting
Menu: System Control Unit/Parameter
This menu serves to set the SCU parameters:
● Measuring screen
● Sequence control of MCS100FT
● Logbook
● Interfaces
● etc.
5.6.9 Maintenance
Menu: System Control Unit/Maintenance
5.6.9.1 Tests
Menu: System Control Unit/Maintenance/Tests
This menu serves to test the analog and digital interfaces.
Setting SCU parameters  SCU Technical Information“.
Interface menu explanation:  “SCU Technical Information“ manual
The “Save” button has no significance.
Tests
Manual Adjust
Hardware Reset
Maintenance Mode
/System Control Unit/Maintenance/
SCU
MCS100FT
Measure
 p. 45, §5.6.9.1
 p. 49, §5.6.9.2
 p. 49, §5.6.9.3
 p. 49, §
Digital Input
Digital Output
Analog Input
Analog Output
/System Control Unit/Maintenance/Tests/
SCU
MCS100FT
Measure
 p. 46
 p. 47
 p. 48
 p. 49