SICK MCS100FT - Testing SCU Analog Outputs

Operation
MCS100FT · Operating Instructions · 8011893 V2-1 · © SICK AG 49
Subject to change without notice
● Analog outputs
Menu: System Control Unit/Maintenance/Tests/Analog Output
 “Mark” desired tests and then perform these tests with “Test”.
The following Test menu appears:
5.6.9.2 Manual adjust
5.6.9.3 Hardware reset
Menu: System Control Unit/Maintenance/Hardware Reset
Triggers an SCU restart and therefore the MCS100FT as well.
Designation Remark
Index Number of the selected output. Shown automatically.
Module Topographic addressing (
 “SCU Technical Information“ manual). Shown
automatically.
Test Parameter [mA] Input: Setpoint value of the current to be output.
AO(n)O [mA] Actual value of the current output.
AO(n) [phys. Unit] Output value converted to the physical unit.
This menu is not used in the SCU.
Please use the appropriate MCS100FT or FID-100FT menu.
/System Control Unit/Maintenance/Tests/Analog Output
SCU
MCS100FT
Measure
Index Module Source Zero Range1 Start Range1 End Range1 active Range2 Start Range2 End Range2 active
1 N1M10AO01(AO02) rv1 4mA 0.0E00 1.0E02 0.0E00 1.0E02
2 N1M10AO02(AO02) rv2 4mA 0.0E00 1.0E02 0.0E00 1.0E02
3 N1M11AO02(AO02) rv3 4mA 0.0E00 1.0E02 0.0E00 1.0E02
etc.
Save Mark Test
/System Control Unit/Maintenance/Tests/Analog Output
SCU
MCS100FT
Measure
1Index
AO(n) [phys. Unit]
N1M10AO01(AO02)Module
AO(n)O [mA]
Cancel
Test Parameter [mA]
12
12
701
/System Control Unit/Maintenance/Hardware Reset
SCU
MCS100FT
Measure
Hardware Reset