SICK MCS100FT - Testing SCU Analog Inputs

48 MCS100FT · Operating Instructions · 8011893 V2-1 · © SICK AG
Operation
Subject to change without notice
● Analog inputs
Menu: System Control Unit/Maintenance/Tests/Analog Input
 “Mark” desired tests and then perform these tests with “Test”.
The following Test menu appears:
Designation Remark
Index Number of the selected input. Shown automatically.
Module Topographic addressing (
 “SCU Technical Information“ manual). Shown
automatically.
AI(n)I [mA] Current measured on the analog input.
AI(n) [phys. Unit] Converted physical measured value.
/System Control Unit/Maintenance/Tests/Analog Input
SCU
MCS100FT
Measure
Index Module Name Unit Gas Condition Zero Range Start Range End
1 N1M14AI01(AI02) AI1 4mA ---- 4mA 0.0E00 1.0E02
2 N1M14AI02(AI02) AI2 4mA ---- 4mA 0.0E00 1.0E02
3 N1M14AI03(AI02) ai3 4mA ---- 4mA 0.0E00 1.0E02
etc.
Save Mark Test
/System Control Unit/Maintenance/Tests/Analog Input
SCU
MCS100FT
Measure
1Index
AI(n) [phys. Unit]
N1M14AI01(AI02)Module
AI(n)I [mA]
Cancel
12
701