SICK MCS100FT - MCS100 FT Maintenance Operations; Switching MCS100 FT Operating Modes

Operation
MCS100FT · Operating Instructions · 8011893 V2-1 · © SICK AG 69
Subject to change without notice
5.7.9 Maintenance
Menu: MCS100FT/Maintenance
5.7.9.1 Operation Mode Switch
Menu: MCS100FT/Maintenance/Operation Mode Switch
This menu serves to switch the MCS100FT to the desired operating state.
5.7.9.2 Status Reset
Menu: MCS100FT/Maintenance/Status Reset
All pending messages are reset.
Designation Remark
Measuring Switch the MCS100FT to measuring operation.
Maintenance Switch Maintenance mode on.
- A status signal ( delivered system documentation) is set.
- The yellow status indicator on the cabinet door lights.
- An entry is made in the logbook.
Back-Purge Backflushing runs once. Duration and cycle as per parameter settings in
 p. 53, §5.7.6.1. Then automatic return to “Measuring”.
Purge MCS100FT sampling probe, sample gas line and gas path are purged with
instrument air.
A status signal ( delivered system documentation) is set.
Device State Shows the operating state.
State Active Since State Active Since
of For programs running automatically: Remaining time.
Designation Remark
Status Reset Reset all pending messages.
Response Result of reset.
Operation Mode Switch
Status Reset
/MCS100FT/Maintenance
SCU
MCS100FT
Measure
 p. 69, §5.7.9.1
 p. 69, §5.7.9.2
/MCS100FT/Maintenance/Operation Mode Switch
SCU
MCS100FT
Measure
Measuring
Maintenance
Purge
Back-Purge
14739 s
Device State Measure
State Active Since
0 sof
/MCS100FT/Maintenance/Status Reset
SCU
MCS100FT
Measure
Status Reset
Response