18 Clinitek Advantus Operator’s Guide
Operating the System
Check the Strip Loading Station
Ensure that the strip loading station and push bar are clean and in the correct
position. If contaminants are present, remove and clean the push bar, the
platform, and the moving table.
Change the Starting Sequence Number
This number increments with each strip placed onto the analyzer. If necessary,
use this procedure to change the number.
1. Select
SEQ #.
A numeric keypad displays.
2. Enter the new sequence number.
Change individual digits as needed:
a. Select
Move Left or Move Right to move the cursor to the digit to
change.
b. Enter the correct number.
Select
00001 to reset the number.
3. Select
Enter.
Change the Technician Identification
You can activate the Tech ID option during analyzer setup. Refer to Tech ID‚
page 102 for more information.
1. Select
Menu.
2. Select
Tech ID.
A numeric keypad displays.
3. Enter an identification number of up to 13 digits.
a. Select
A-Z to enter alphabetic characters.
b. Select
Enter to return to the numeric keypad.
4. Select
Enter to save the Tech ID.
Print Information
1. Select Menu.
2. Select
Print to print:
• the ID list if a loadlist exists in memory
• confirmation of the last calibration
• a report of the setup parameters
To Next Page
Loading...
Need help?
General
