Siemens Clinitek Advantus User Manual

Clinitek Advantus Operator’s Guide 73
System Configuration
6. Place the analyzer on a firm, level work surface in the designated work
area.
7. Ensure that the analyzer is level, and that the back and sides of the
analyzer are at least 7.6 cm (3 in) from any adjacent wall or analyzer.
8. Locate the piece of foam packing that is under the read area cover.
The foam has a red tag attached.
9. Remove the foam by gently pulling the red tag down and forward.
Figure 22 Remove the Foam

Siemens Clinitek Advantus Specifications

General

Test Types	Urinalysis
Interface	RS-232, USB
Calibration	Automatic calibration
Measurement Principle	Reflectance photometry
Sample Type	Urine
Power Supply	100-240 VAC, 50/60 Hz
Type	Urine analyzer
Display	Touchscreen
Reagent Type	Test strips
Measurement Parameters	Glucose, Bilirubin, Ketone, Specific Gravity, Blood, pH, Protein, Urobilinogen, Nitrite, Leukocytes