101 / 109
BA 5846 en 05/2015
10.2.4 Clean the air filter
Note
A period of 3 months has been specified for cleaning the air filter.
If a layer of dust has built up, the air filter must already be cleaned, whether or not the period of 3 months
has expired.
Note
If the air filter is protected with a filter cap, the filter cap must be removed for cleaning the air filter. After
the air filter has been cleaned, the filter cap must be fitted again.
• Unscrew the air filter including the reducing screw.
• Clean the air filter using a suitable cleaning agent.
• Dry the air filter and/or blow out with compressed air.
WARNING
Risk of eye injury through compressed air
Remains of water and/or dirt particles may be harmful to the eyes.
Wear suitable protective glasses.
NOTICE
Material damage
Risk of damage to the gear unit through entry of foreign bodies.
Foreign bodies must be prevented from entering the gear unit.
10.2.5 Check friction linings of torquelimiting backstop
WARNING
Risk of injury through movable plant parts
After having stopped the motor, there is a danger that the load is not safely held in its position and can
run in reverse direction at high speed.
The slipping torque was set at the correct value at the works; it must not be changed.
Note
As a rule, the backstop operates without wear. The only wear that might occur would be on the friction
linings, especially in case of frequent slide operations. As a precaution, the dimension "x
min.
" must be
checked after each releasing operation (type FXRT only) and then every 12 months.
Note
As a rule, the backstop operates without wear. The only wear that might occur would be on the friction
linings, especially in case of frequent slide operations.
To Next Page
Loading...
