13 / 109
BA 5846 en 05/2015
2. General notes
2.1 Introduction
These instructions are an integral part of the gear unit supplied and must be kept in its vicinity for reference
at all times.
NOTICE
Material damage
Risk of damage to the gear unit or disruptions to operation.
All persons carrying out work on the gear unit must have read and understood these instructions and
must adhere to them.
Siemens accepts no responsibility for damage or disruptions to operation caused by disregard of these
instructions.
The "FLENDER gear unit" described in these instructions has been designed for use as a lifting and luffing
gear unit. Possible areas of use for gear units of this type include conveyor systems and lifting equipment.
The gear unit is designed only for the application specified in section 1, "Technical data". Other operating
conditions must be agreed by contract.
The gear unit has been manufactured in accordance with the state of the art and is delivered in a condition
for safe and reliable use. The gear unit complies with the requirements in Directive 94/9/EC.
The gear unit must be used and operated strictly in accordance with the conditions laid down in the contract
governing performance and supply agreed by Siemens and the customer.
The gear unit described in these instructions reflects the state of technical development at the time these
instructions went to print.
In the interest of technical progress we reserve the right to make changes to the individual assemblies and
accessories which we regard as necessary to preserve their essential characteristics and improve their
efficiency and safety.
2.2 Copyright
The copyright to these instructions is held by Siemens AG.
These instructions must not be wholly or partly reproduced for competitive purposes, used in any
unauthorised way or made available to third parties without our agreement.
Technical enquiries should be addressed to the following works or to one of our customer services:
Siemens AG
Am Industriepark 2
46562 Voerde
Tel.: +49 (0)2871 / 92‐0
Fax: +49 (0)2871 / 92‐1544
To Next Page
Loading...
