Siemens FLENDER K SH Series - Oil Level Monitoring System; Bearing Monitoring Systems

41 / 109
BA 5846 en 05/2015
5.14 Oillevel monitoring system
The gear unit may be fitted with an oillevel limit switch for monitoring the oil level. The oillevel monitoring
device has been designed for checking the oil level when the gear unit is at a standstill, prior to operating
start.
When using an oillevel monitoring device the oil level in the gear unit must be horizontal.
For a detailed illustration of the gear unit and the position of the addon parts, refer to the drawings in the
gearunit documentation.
Note
For the operation and maintenance the operating manuals specified in the orderspecific annex must be
observed.
For technical data and control information, refer to the orderspecific list of equipment.
5.15 Bearingmonitoring system
5.15.1 Bearing monitoring by Pt 100 resistance thermometer
The gear unit may have been fitted with Pt 100 resistance thermometers for monitoring the bearings. In
order to measure the temperatures and/or temperature differences, the Pt 100 resistance thermometers
must be connected to a suitable evaluating instrument provided by the customer. The resistance
thermometers have a connection head for the wiring. A twowire circuit is provided by the manufacturer.
However, the customer may also fit a three or fourwire circuit.
Fig. 19: Bearing monitoring by Pt 100 resistance thermometer
For a detailed illustration of the gear unit and the position of the addon parts, refer to the drawings in the
gearunit documentation.
Note
For the operation and maintenance the operating manuals specified in the orderspecific annex must be
observed.
For technical data and control information, refer to the orderspecific list of equipment.