Siemens FLENDER K SH Series - Fitting with Integrated du Bush

62 / 109
BA 5846 en 05/2015
• Check the hollow and drivenmachine shafts for any damage on the bearing seats and edges.
If necessary, rework the parts with a suitable tool and clean them again.
Note
The bore of the hollow shaft and the drivenmachine shaft must be absolutely free of grease in the area
of the shrinkdisk seat.
This is essential for safe and reliable torque transmission.
Contaminated solvents, dirty cloths and cleaning agents containing oil (such as paraffin or turpentine)
are not suitable for removing grease.
6.7.2.1 Fitting with integrated DU bush
• Fit the gear unit by means of nut and threaded spindle. The support is provided by the hollow shaft.
NOTICE
Material damage
Risk of damage to the gear unit through canting during fitting work.
When fitting the gear unit on the drivenmachine shaft, the hollow shaft must be in line with the
drivenmachine shaft. Any canting must be avoided.
7
5
6
3
1
4
2
Fig. 34: Hollow shaft in shrinkdisk design, fitting with integrated DU bush
1 Machine shaft
2 Hollow shaft
3 DU bush
4 Nut
5 Threaded spindle
6 Nut
7 End plate