Siemens FLENDER K SH Series - Gear Unit with Torque­limiting Backstop

43 / 109
BA 5846 en 05/2015
"C""D"
Fig. 22: Accelerometer complete ("C") and threaded hole ("D") for variants 5A and 5B
For a detailed view of the gear unit with sensors added-on, please refer to the drawings in the gear-unit
documentation.
Note
For operation of the sensors, the special operating instructions should be observed.
5.15.4 Gear unit with torquelimiting backstop
Note
If a torquelimiting backstop (see item 5.7.1) is used on gear units, the slipping torque will already have
been set at the correct value during the manufacturing process. Resetting or checking during startup is
not necessary.