Siemens FLENDER K SH Series - Demounting

54 / 109
BA 5846 en 05/2015
6.5.3 Demounting
• Remove the axial securing device from the hollow shaft.
• If frictional corrosion has occurred on the seating surfaces, rustreleasing agent may be used to
facilitate forcing off the gear unit. The rust releaser can be injected through the pressureoil connection
(see figure 25), using a pump.
• When the rustreleasing agent has taken effect, pull the gear unit off using the device (see figures 27
and 28).
• Removing the gear unit from the drivenmachine shaft can be done as follows:
─ preferably using a hydraulic lifting unit,
─ using forcingoff screws in an end plate (see figure 28), or
─ using a central threaded spindle.
Note
The end plate and/or the auxiliary plate for forcing off the gear unit are not included in the Siemens
delivery.
5
4
6
3
1
2
7
Fig. 27: Hollow shaft with parallel keyway, demounting with hydraulic lifting unit
1 Machine shaft
2 Hollow shaft
3 Parallel key
4 Hydraulic lifting unit
5 Threaded spindle
6 Pressure-oil connection
7 Auxiliary plate for forcing out